NAT COMF PRODUCT THRU THE WALL UNIT
- Air Flow: Horizontal
- Category: Residential Heat Pump
- Refresh Carrier Images: Done
- Sx.e Stocking Unit: Each
- Sx.e Vendor: NATIONAL COMFORT PRODUCTS
The Comfort Pack is a completely self-contained, pre-charged, heating and cooling system for each individual living unit in your multifamily complex. Since this product is completely self-contained there is no necessary brazing, charging or leak checking. This process has already been done for you at the factory. Every unit runs through an extensive quality control process where each unit is precisely charged, leak checked and ran in both cooling and heating to assure you that the product is ready for immediate installation. The Comfort Pack eliminates the need of an outside condensing unit, external refrigerant lines, separate cooling coils as well as additional drain pans, making our Comfort Pack the optimal solution for multi-family construction.
Features & Benefits
- Self-Contained Heating and Cooling Unit
- Easy, Reachable Access Port
- Completely Pre-Charged and Pre-Wired
- Slide Out Chassis
- Totally Polarized Molex Electrical Plug Connections on Cooling Chassis
- Internal Automatic Reset Thermal Limit
- Internal Fusing
- Copper Tube with Enhanced Aluminum Fin Coil
- Direct Spark Ignition with Unique
- Single Gas Orifice
- Easy View Sight Glass for Diagnostic Lights and Flame
- Diagnostic LEDs Visible through Furnace Door
- Sealed Combustion Chamber
Specifications
- Type: High Efficiency, Self-Contained
- Voltage Rating: 208 to 230 Volt AC
- Current Rating: 16.6 Amp (Total), 10.9 Amp Rated Load/61.6 Amp Locked Rotor (Compressor), 1.8 Amp Full Load/3.6 Amp Locked Rotor (Outdoor Fan Motor), 3.9 Amp Full Load (Indoor Blower Motor), 19.3 Amp (Minimum Circuit Capacity), 30 Amp (Maximum Overcurrent Protector)
- Frequency Rating: 60 Hertz
- Number of Phases: 1
- Power Rating: 1/2 HP (Indoor Blower Motor), 1/4 HP (Outdoor Fan Motor)
- Cooling Capacity: 24000 BTU/Hour
- Temperature Control Type: Thermostat
- Connection Type: Polarized Molex Plug
- Installation: Wall
- Enclosure Material: Steel
- Enclosure Finish: Pre-Painted Galvanized
- Size: 28 Inch Width x 31-7/16 Inch Depth x 43 Inch Height
- Approval: ETL (Canada and US)
- Heating Capacity 38000 BTU/Hour (Input), 30400 BTU/Hour (Output)
- Refrigerant Type R410A
- Energy Efficiency Ratio 9.2 EER
- Thermal Efficiency 80 Percent
- Airflow Rate 405 to 850 CFM at 0.1 Inch WG
- Includes Universal Chassis, 16 Inch x 25 Inch Filter, High Efficiency Compressor, Pre-Painted Stamped Exterior Grille, Copper Tube with Enhanced Aluminum Fin Coil, 5 Speed DC Indoor Motor
- Applicable Standard AHRI